[. . . ] ENF002-1 Power supply The tool should be connected only to a power supply of the same voltage as indicated on the nameplate, and can only be operated on single-phase AC supply. They are double-insulated in accordance with European Standard and can, therefore, also be used from sockets without earth wire. Use of this tool to sand some products, paints and wood could expose user to dust containing hazardous substances. [. . . ] 9 & 10) Insert the notch of the paper dust bag into the guide of the paper dust bag holder. Open the paper clamp by raising on the lever to release from the locking port and then Insert the paper end into the clamping part, aligning the paper edges even and parallel with the sides of the base. Once the paper is in place, return the lever to its original position. 3) Repeat the same process for the other end of the base, maintaining the proper paper tension. After inserting the paper, make sure the clamping part hold it securely. Otherwise the paper will be loose and subject to slippage, resulting in uneven sanding operation. 4) When using the dust bag, make holes in the abrasive paper using the punch plate as follows: 1. Place the punch plate over the abrasive paper so that the bent sides of the punch plate are flush with the paper edges. Model BO4555 only NOTE: Use Makita hook-and-loop sandpaper with this sander. Be sure to align the holes on the sandpaper with the holes on the pad (the dust will be sucked into these holes; it is therefore important to leave them open). nOTE: · If the sandpaper is in good condition, save it for further use. Excessive pressure may decrease the sanding efficiency, damage the abrasive paper and/or shorten tool life. A finishing sander is generally used to remove only a small amount of material at a time. Since the quality of the surface is more important than the amount of stock removed, do not bear down on the tool. Always be sure that the tool is switched off and unplugged before attempting to perform inspection or maintenance. To maintain product SAFETY and RELIABILITY, repairs, carbon brush inspection and replacement, any other maintenance or adjustment should be performed by Makita Authorized Service Centers, always using Makita replacement parts. These accessories or attachments are recommended for use with your Makita tool specified in this manual. The use of any other accessories or attachments might present a risk of injury to persons. [. . . ] For European countries only ENH101-13 EC Declaration of Conformity We Makita Corporation as the responsible manufacturer declare that the following Makita machine(s): Designation of Machine: Finishing Sander Model No. /Type: BO4555, BO4556, BO4557, BO4558 are of series production and Conforms to the following European Directives: 98/37/EC until 28th December 2009 and then with 2006/42/EC from 29th December 2009 And are manufactured in accordance with the following standards or standardised documents: EN60745 The technical documentation is kept by our authorised representative in Europe who is: Makita International Europe Ltd. The declared vibration emission value has been measured in accordance with the standard test method and may be used for comparing one tool with another. [. . . ]